Lantronix Ethernet - Manual (Page 72)

Setup Mode: Advanced Settings
WiBox2100E User Guide 72
Default Settings
Select 7 Default Settings from the Change Setup menu to reset the unit’s Channel 1
configuration, Channel 2 configuration, Security, and Expert settings to the factory
default settings.
The server configuration settings for IP address, gateway IP address, netmask, and
WLAN remain unchanged.
Defaults for all settings are listed below.
Channel 1 Configuration
Baudrate 9600
I/F Mode 4C (1 stop bit, no parity, 8 bit, RS-232C)
Port No 10001
Connect Mode C0 (always accept incoming connection; no active
connection startup)
Hostlist Retry Counter 3
Hostlist Retry Timeout 250 (msec)
Send Character 0x0D (CR)
All other parameters 0
Channel 2 Configuration
Baudrate 9600
I/F Mode 4C (1 stop bit, no parity, 8 bit, RS-232C)
Port No 10002
Connect Mode C0 (always accept incoming connection; no active
connection startup)
Hostlist Retry Counter 3
Hostlist Retry Timeout 250 (msec)
Send Character 0x0D (CR)
All other parameters 0
WLAN Settings
Enable WLAN Y (Yes)
Topology 1 (AdHoc)
Network Name LTRX_IBSS