Linksys PERFORMER SS210 - Manual (Page 12)

1 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
3. Included with the stove are two 15-1/4”x 11-1/2”x 1/2” thick ceramic fiber blankets. Install one blanket above the baffle brick
and to each side of the support bracket. Make sure that the blankets are fully to the rear.
4. Next, install the front baffle bricks #33-38 under the ceramic fiber blankets carefully so as not to damage the ceramic fiber
blankets. Bricks #33-38 rest rest in the front two secondary tubes.
CAUTION: Make sure the ceramic fiber blankets are down flat on the baffle bricks, pulled together in the center
so that no gap exists between them and do not project beyond bricks #-8.
These brick sizes may be slightly smaller to adjust for steel and firebrick tolerances beyond our control. Be sure to measure
and mark bricks with their numbers when removing.
WARNING: IF THE BRICKS ARE NOT INSTALLED EXACTLY AS SHOWN BELOW, THEY COULD FALL OUT OF
PLACE DURING REFUELING OR BURNING OF THE STOVE CAUSING SERIOUS INJURY.
Firebox Brick Layout as Viewed from the Front
*
*
* Bricks 6 and 10 fit up against the back of the firebox.
Secondary Tubes Supporting Brackets
Secondary Tubes Supporting Brackets
Figure 6
Figure 8
Figure 7 Side View of the Firebox Top View of Baffle Bricks as Viewed from the Front.
Brick Sizes
A = -1/4”x 9”
B = 4-1/”x 5-1/”
C = 4-1/”x 6-1/4”
D = ”x 6-1/4”
E = ”x 9”
F = 4-1/”x 9”
G = 1-1/”x 9”
H = 1-1/”x ”
K = 1-1/”x 5-1/”
M = -1/4”x 6-1/4”
S = -1/8”x 9”
Stainless Pin
Stainless Pin
Ceramic
Fiber
Blanket