LG DVT418 - Manual (Page 35)

35
Operation
Sleep Timer Setting
You can set the DVD/CD Receiver to turn off
automatically at a specified time.
1. Press SLEEP to set the desired sleep time.
The SLEEP indicator and sleep time appears in the
display window.
2. Each time you press SLEEP the setting
changes in the following order.
SLEEP 180 →150 →120→90 →80 → 70 → 60→ 50 → 40 →
30 → 20 →10 →OFF
Note:
• You can check the time remaining before the
DVD/CD receiver turns off.
Press SLEEP. The remaining time appears in the
display window.
Dimmer
This function will change the brightness of the display
window on the front panel during in power-on status.
Press the DIMMER repeatedly.
Mute
Press MUTE to mute your unit.
You can mute your unit in order, for example, to
answer the telephone, “MUTE” indicator flashes in the
display window.
Using Headphone Jack
Connect a stereo headphone plug ( 3.5mm) into the
PHONES connector.
The speakers are automatically disconnected when
you plug in a headphone (not supplied).
Selecting input source
You can use VCRs or other units connected to the
AV1, AV2 connectors, Coaxial connector or Optical
connector. Refer to the owner’s manual supplied with
the unit for further information on the operation.
Press AUX repeatedly on the remote control to
select the desired input source.
Each time you press this button, the mode of the
function changes in the following sequence:
AV 1: for selecting the analog signal from AV1 AUDIO IN
(L/R) & VIDEO IN Connectors.
AV 1 OPT: for selecting the optical digital signal from AV1
VIDEO IN & OPTICAL IN Connector.
AV 1 COAX: for selecting the coaxial digital signal from
AV1 VIDEO IN & COAXIAL IN Connector.
AV 2: for selecting the analog signal from AV2 AUDIO IN
(L/R) & VIDEO IN Connectors.
Notes:
• The Optical input function is available only when the
other unit’s Sampling Frequency is 32 ~ 96kHz.
• You can also select the input source by pressing
FUNC./PLAY button on the front panel.
Press and hold down this button about 3 seconds,
then press repeatedly to select input source.