Lexmark 3200 - Manual (Page 22)

Scan to permanent e-mail destinations
17
5 Press Go/Send to start scanning.
Note: If you are using the flatbed of the scanner, watch the control panel for messages.
If prompted to Place Next Or Stop , place the next page on the flatbed and then
press Go/Send to continue scanning. Press Stop/Clear when all the pages have
been scanned.
Scan to permanent e-mail destinations
For e-mail addresses you frequently use, permanent e-mail destinations can be set up by your
network administrator. Once a permanent destination is created, it is available on the MFP control
panel.
1 Locate the MFP where the permanent destinations are stored.
2 Load all pages in the automatic document feeder of the scanner. Place the pages according
to the drawing on the scanner.
3 On the control panel, press Fax/Scan Mode repeatedly until you see SCAN
→
EMAIL .
4 Press Menu > repeatedly until you see your e-mail destination.
Note: If you want to send to multiple e-mail destinations, press Select when you see each
destination, and then Menu > until you see your next choice. An asterisk appears
beside your selections. Your e-mail is sent to each destination you selected and the
last destination appearing in the control panel display.
5 Press Go/Send to start scanning.
Note: If you are using the flatbed of the scanner, watch the control panel for messages.
If prompted to Place Next Or Stop , place the next page on the flatbed and then
press Go/Send to continue scanning. Press Stop/Clear when all the pages have
been scanned.