Lexmark 3200 - Manual (Page 48)

Send fax status
43
Send fax status
Receive fax status
Message Description
Enter phone #
xxx-xxx
Prompt to use the numeric keypad to enter the fax recipient
phone number.
Scanning to Mem
Busy ¨
Original documents are being scanned to memory.
Dialing…
Ready 100% 1
Fax recipient number is being dialed.
Connect <Baud><ECM>
Ready 100% 1
Shows connection and baud rate with the receiving fax
machine. If error correction mode is being used, ECM is
displayed on the control panel.
Sending Page X
Ready 100% 1
Page X is currently being sent.
Call Complete
Ready 100% 1
All the pages of the fax have been sent and the phone line
connection has hung up.
Shortcut xx Fax
Destination Name
Fax shortcut has been initiated by pressing #, and then entering
the shortcut number on the numeric keypad. Destination Name
is the name assigned to the fax recipient.
Place Next
Or Stop
1 Place the next page on the flatbed.
2 Press Go to continue sending pages.
3 Press Stop to end the fax transmission.
The control panel resets to copy mode and the Ready message
appears on the display.
Message Description
Receiving Fax…
Ready 100% 1
MFP is receiving an incoming fax.
Connect <Baud><ECM>
Ready 100% 1
Shows connection and baud rate with the sending fax machine.
If error correction mode is being used, ECM is displayed on the
control panel.
Sender Name
Ready 100% 1
Station name of sending fax machine displays (right justified) on
top line.
Receiving Page X
Ready 100% 1
Page X is currently being received.
Call Complete
Ready 100% 1
All the pages of the fax have been received and the phone line
connection has hung up.