Life Fitness T250 - Manual (Page 4)

3
A
SSEMBLING THE
T
READMILL
Tools Required: Metric Wrench Set, Metric Allen
Wrench Set, Phillips Screwdriver
1. Locate the LEFT UPRIGHT (A) (upright with pre-fed
CONSOLE CABLE). With the HANDLEBAR EXTEN-
SION facing the rear of the unit, position the LEFT
UPRIGHT near the LEFT UPRIGHT BRACKET (B).
Connect the CONNECTORS (C) leading from the
LEFT UPRIGHT and LEFT UPRIGHT BRACKET.
Slide the LEFT UPRIGHT over the LEFT UPRIGHT
BRACKET until fully seated. Install one 9/16" BUT-
TON HEAD SCREW (1) and LOCK WASHER (2)
each in the side and rear mounting holes of the LEFT
UPRIGHT. Finger-tighten the SCREWS.
Caution: Do not pinch the cable when sliding the
LEFT UPRIGHT over the LEFT UPRIGHT
BRACKET.
Locate one UPRIGHT BRACE (D). Using four 9/16"
BUTTON HEAD SCREWS (1) and LOCK WASHERS
(2), secure the UPRIGHT BRACE to the front of the
LEFT UPRIGHT (A) and the FRAME (E). Finger-tight-
en the SCREWS.
Locate the RIGHT UPRIGHT (F). With the HANDLE-
BAR EXTENSION facing the rear of the unit, position
the RIGHT UPRIGHT near the RIGHT UPRIGHT
BRACKET (G). Slide the RIGHT UPRIGHT over the
RIGHT UPRIGHT BRACKET until fully seated. Install
one 9/16" BUTTON HEAD SCREW (1) and LOCK
WASHER (2) each in the side and rear mounting
holes of the RIGHT UPRIGHT. Finger-tighten the
SCREWS.
Locate the remaining UPRIGHT BRACE (D). Using
four 9/16" BUTTON HEAD SCREWS (1) and LOCK
WASHERS (2), secure the RIGHT UPRIGHT BRACE
to the front of the RIGHT UPRIGHT (F) and the
FRAME (E). Finger-tighten the SCREWS.
2. Locate the HANDRAIL (H). With the stepped extension
end of the HANDRAIL facing right, position the HANDRAIL
between the LEFT and RIGHT UPRIGHTS (A) & (F) at the
HANDRAIL MOUNTING HOLES. Secure the left side of
the HANDRAIL to the LEFT UPRIGHT using the 2 1/8"
BUTTON HEAD SCREW (3) and one LOCK WASHER (2).
Secure the right side of the HANDRAIL to the RIGHT
UPRIGHT using one 9/16" BUTTON HEAD SCREW (1)
and one LOCK WASHER (2).