Lexmark C 910 - Manual (Page 27)

21
Set up the printer and paper handling options
8
Insert the point on the cable
holder into the hole on the back of
the top optional drawer.
9
Place the high-capacity feeder
cable into the holder.
10
Close the cable holder.
Installing height adjustment
spacers
If the pins on the high-capacity feeder
did not align with the holes in the docking
frame you can adjust the height of the
feeder.
You can either remove the factory
installed spacer or add two
spacers between each caster and
the bottom of the high-capacity
feeder.
Use the following steps to add or remove
spacers.
1
Determine the height difference
between high-capacity feeder
alignment pins and the docking
frame.