Life Fitness Hammer Strength OHDMR - Manual (Page 11)

STEP 8:
FIGURE 8
• LOOSELY assemble one RIGHT & one LEFT ADJUSTMENT RACK (9 & 10) to the REAR UPRIGHTS (4) as shown, using eight
3/8 X 3-3/4” FLAT HEAD BOLTS (18), eight 3/8” INT TOOTH LOCK WASHERS (21) and eight 3/8” LOCK NUTS (24). See FIG-
URE 8.
24
3/8 X 3-3/4” 18
21
9
10
4
4
13
12
• Before tightening the ADJUSTMENT RACKS (9 & 10) AND THE 42-1/4” ADJUSTMENT RACKS (7 & 16), slide the LEFT and
RIGHT BAR SUPPORTS (12 & 13) over the ADJUSTMENT RACK and REAR UPRIGHT. Assemble one BAR SUPPORT close to
the top and the other close to the bottom, as shown in DETAIL 8. (Make sure not to cover any bolt heads.) Proceed to tighten all
four bolts in the order shown in DETAIL 8. Repeat this step on the remaining 42-1/4” ADJUSTMENT RACKS.
SETTING ADJUSTMENT RACK WIDTH (SEE DETAIL 8)
DETAIL 8
10
4
1
3
4
2
3
3
• LOOSELY assemble one RIGHT & one LEFT 42-1/4” ADJUSTMENT RACK (7 & 16) to the FRONT UPRIGHTS (3) as shown,
using six 3/8 X 3-3/4” FLAT HEAD BOLTS (18), six 3/8” INT TOOTH LOCK WASHERS (21) and six 3/8” LOCK NUTS (24). See
FIGURE 8.
11
7
16