Life Fitness G5 CABLE MOTION - Manual (Page 9)

9
STEP 3:
‰ Positon two WEIGHT STACK CUSHIONS (23) and GUIDE RODS (22) at the GUIDE ROD BRACKET (B) on the bot-
tom of the FRONT UPRIGHT (1).
NOTE: MAKE SURE THAT THE PLUGGED ENDS OF THE GUIDE RODS (22) ARE FACING UP.
‰ CAREFULLY slide one of the WEIGHT PLATES (46) over the top of the GUIDE RODS (22) and slowly lower the
WEIGHT PLATE on to the WEIGHT STACK CUSHIONS (23).
‰ Continue stacking a total of 15 WEIGHT PLATES (46).
‰ Slide the TOP PLATE (12) over the GUIDE RODS (22) and slowly lower it onto the WEIGHT PLATES (46).
‰ Slide the WEIGHT PIN with RING (14) over the stem of the TOP PLATE (12).
‰ Thread the HEAD PLATE PULLEY ASSEMBLY (10) into the TOP PLATE (12).
‰ Slide one RETAINING RING (67) over the top of each of the GUIDE RODS (22).
‰ Thread one M10 x 50mm HEX TENSION SCREW (63) into each of the two GUIDE ROD RETAINERS (64). Do not
fully thread the M10 x 50mm HEX TENSION SCREWS(63) into the GUIDE ROD RETAINERS (64).
‰ CAREFULLY slide the GUIDE ROD RETAINERS (64) into the hole under the top of the FRONT UPRIGHT (1). Make
sure the M10 x 50mm HEX TENSION SCREWS (63) in the GUIDE ROD RETAINERS (64) are facing up.
‰ Push the GUIDE ROD RETAINERS (64) up high enough so that the GUIDE RODS (22) can be placed under them.
‰ Lower the GUIDE ROD RETAINERS (64) over the GUIDE RODS (22).
‰ Slide the RETAINING RINGS (67) up. Use External Snap Ring Pliers to secure the RETAINING RINGS (67) into the
groove on the GUIDE ROD RETAINERS (64).
‰ Tighten all frame bolts securely.