Linksys BUSINESS SPA922 - Manual (Page 68)

Linksys SPA9x2 Phone Administration Guide 61
Using HTTPS
Provisioning Basics
Parameter Description
Upgrade_Enable Enables firmware upgrade operations independently of resync actions.
Defaults to Yes.
Upgrade_Error_Retry_
Delay The upgrade retry interval (in seconds) applied in case of upgrade failure.
The device has a firmware upgrade error timer that activates after a failed
firmware upgrade attempt. The timer is initialized with the value in this
parameter. The next firmware upgrade attempt occurs when this timer
counts down to zero.
The default is 3600 seconds.
Downgrade_Rev_Limit Enforces a lower limit on the acceptable version number during a
firmware upgrade or downgrade. The device does not complete a
firmware upgrade operation unless the firmware version is greater than or
equal to this parameter.
The default is (empty).
Upgrade_Rule This parameter is a firmware upgrade script with the same syntax as
Profile_Rule. Defines upgrade conditions and associated firmware URLs.
The default is (empty).
Log_Upgrade_Request
_Msg Syslog message issued at the start of a firmware upgrade attempt.
The default is
$PN $MAC -- Requesting upgrade $SCHEME://$SERVIP:$PORT$PATH
Log_Upgrade_Success_
Msg Syslog message issued after a firmware upgrade attempt completes
successfully.
The default is
$PN $MAC -- Successful upgrade $SCHEME://$SERVIP:$PORT$PATH -- $ERR
Log_Upgrade_Failure_
Msg Syslog message issued after a failed firmware upgrade attempt.
The default is
$PN $MAC -- Upgrade failed: $ERR.
License Keys This field is empty.