Lexicon 570 - Manual (Page 16)

11
www.remotepossibilities.com
Configuring the Alarm Dialer
The Messenger 570 system continually monitors all inputs for alarm set-points that have been violated. If a set-
point has been exceeded for a designated period of response time, the Messenger 570 system recognizes this as
the existence of an alarm condition.
It will send the message to up to eight designated telephone numbers anywhere on or off site and at any time. If
the calls are unanswered, the Messenger 570 system will wait a pre-set length of time and perform the complete
dial-out sequence again.
The alarm dial-out sequence will continue − even if the alarm condition has cleared − until the alarm has been
externally acknowledged.
To fully configure the alarm dialer, use the INP S command to set the alarm set-points and the PHO O
command to program the dialing directory.