Lightolier 4X9EM - Manual (Page 2)

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:4X9EM
A0502 Page 2 of 4
A COMPANY
631 Airport Road, Fall River, MA 02720
90
°°
Instructions for replacing BALLAST:
ALL SERVICING MUST BE PERFORMED BY QUALIFIED PERSONNEL ONLY.
1. This unit has more than one power supply connection point. Make certain that the switch (if the fixture is switched) and
the unswitched lines to the EMERGENCY BALLAST (see page 3) are turned off at the fuse box.
2. Disconnect the battery pack INVERTER CONNECTORS (Fig. 1), located inside the SWITCH BOX (see page 3) to
prevent electrical shock from the battery pack.
3. Remove REFLECTOR TRIM & lamp(s) (See IS:4X4, section E.).
4. Undo WINGNUT(s) and remove UPPER REFLECTOR.
5. Remove SCREWS that secure BALLAST PLATE to HOUSING.
6. Partially remove BALLAST PLATE from HOUSING.
7. Disconnect wire leads from BALLAST push-in terminals.
(Insert pin or paper clip in RELEASE SLOT, Fig. 2a)
8. Remove BALLAST from BALLAST PLATE (Fig. 3), and install new BALLAST.
9. Insert wire leads into BALLAST. Follow appropriate wiring diagram on page 4.
10. Reattach BALLAST PLATE, UPPER REFLECTOR, lamp(s), and REFLECTOR TRIM.
FIG. 1
INVERTER
CONNECTORS
UPPER
REFLECTOR
SCREW
HOUSING
WINGNUT
BALLAST
PLATE
FIG. 2a
RELEASE
SLOT
FIG. 2
BALLAST BALLAST PLATE
FIG. 3
INSTALLATION PROCEDURE FOR: 4X9 AND 9X9 MATRIX SERIES RECESSED
COMPACT FLUORESCENT EMERGENCY LIGHTING FRAME-IN KITS