Lightolier 4X9EM - Manual (Page 3)

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:4X9EM
A0502 Page 3 of 4
A COMPANY
631 Airport Road, Fall River, MA 02720
Instructions for replacing EMERGENCY BALLAST:
ALL SERVICING MUST BE PERFORMED BY QUALIFIED PERSONNEL ONLY.
1. This unit has more than one power supply connection point. Make certain that the switch (if the fixture is switched) and
the unswitched lines to the EMERGENCY BALLAST are turned off at the fuse box.
2. To remove SWITCH BOX from ceiling: Disconnect the battery pack inverter connectors (see page 2) located inside the
SWITCH BOX to prevent electrical shock from the battery pack. Disconnect switch and indicator light leads, and
locknut inside SWITCH BOX. Remove SWITCH BOX.
3. Disconnect all EMERGENCY BALLAST connections inside fixture JUNCTION BOX.
4. Disconnect all leads from A/C BALLAST. DO NOT disconnect any wire leads from lamp socket(s). Remove LOCKNUT
from BALLAST PLATE, and remove BALLAST PLATE with A/C BALLAST. See page 2 for detailed instructions on A/C
BALLAST removal and replacement.
5. Loosen RETAINING SCREW on EMERGENCY BALLAST MOUNTING BRACKET, and lift EMERGENCY BALLAST
MOUNTING BRACKET from HOUSING wall.
6. Feed EMERGENCY BALLAST MOUNTING BRACKET and EMERGENCY BALLAST through opening.
7. Remove emergency ballast from MOUNTING BRACKET and replace with new EMERGENCY BALLAST.
8. Re-install all hardware, including fiberglass sleeves over wiring.
9. Re-connect all electrical connections. Follow appropriate wiring diagram on page 4.
SWITCH BOX
JUNCTION BOX
A/C BALLAST BALLAST PLATE
LOCKNUT
HOUSING
RETAINING SCREW
EMERGENCY BALLAST
MOUNTING BRACKET
VIEW LOOKING INSIDE FIK SIDE VIEW
INSTALLATION PROCEDURE FOR: 4X9 AND 9X9 MATRIX SERIES RECESSED
COMPACT FLUORESCENT EMERGENCY LIGHTING FRAME-IN KITS
EMERGENCY
BALLAST