Lucent Technologies DEFINITY Enterprise Communications Server - Manual (Page 16)

DEFINITY® Enterprise Communications Server Release 7
Console Operations Quick Reference
555-230-890
Issue 3
June 1999
Console Operations
12 Basic Operation
To make calls not using the selector console, perform the following:
1. Press the START button or an idle call appearance button.
■
You hear a dial tone.
■
The call appearance lamp goes on.
■
The Position Available lamp goes off.
2. Dial the extension.
■
You hear a ringback tone.
■
The display shows the dialed number.
■
The ringback tone stops when the called party answers.
3. To end the call, press the RELEASE button.
■
You are disconnected from the call.
■
The call appearance lamp goes off.
■
The display goes blank.
■
The Position Available lamp goes on.
■
The console returns to the normal operating mode.
NOTE:
Before the call completes, you can press the CANCEL or RELEASE
button to end the call attempt. If you press CANCEL , you get another
dial tone. If you press RELEASE , the console returns to the normal
operating mode.
Making a call to an outside number requires an outgoing trunk. You can access an
outgoing trunk in two ways:
■
You can make a call to an outside number by dialing a code for the
Automatic Route Selection feature or a specific trunk group, or
■
You can make a call to an outside number by pressing the trunk group
select button for the desired trunk.
NOTE:
Trunk group select buttons are not available at some locations. If the
trunk group select buttons are not administered, dial the trunk access
codes using the dial keypad.
230890_3.bk Page 12 Tuesday, April 20, 1999 12:57 PM