Lowrance electronic AirMap 500 - Manual (Page 81)

75
Map Data
This menu lets you turn the map off, if desired, which turns the map
screen into a GPS plotter; turn off or on the pop-up map info boxes;
draw the map boundaries or boxes around the areas of detail; or fill
land areas with gray. You can also turn on or off Map Overlays, which
display latitude and longitude grid lines or range rings on the map.
This menu lets you select Navionics Maps; for instructions, see the
Navionics Charts entry in this section.
To get to Map Data:
1. From the Map Page, press
MENU |
↓ to
M
AP
D
ATA
| ENT .
Map Menu, left, Map Data Menu, right.
Show Map Data
Press
MENU |
↓ to
M
AP
D
ATA
| ENT . Press ENT to adjust the level of detail
using E ARTH M AP D ETAIL
. After the option is set, press EXIT to return to
the page display.
NOTE:
In Aviation Mode, turning E
ARTH
M
AP
D
ETAIL
to Off will clear all land
map information from the map display, but the aviation map re-
mains. You can also select other degrees of detail, from Low to
High. This is a good way to quickly control clutter if you need to fo-
cus on just the air map.
Pop-up Map Info
Press
MENU |
↓ to
M AP D ATA
| ENT . Press
↓ to
P OPUP M AP I NFO
. With the op-
tion highlighted, press ENT to check it (turn on) and uncheck it (turn
off). After the option is set, press EXIT to return to the page display.
Map Boundaries
Press
MENU |
↓ to
M
AP
D
ATA
| ENT . Press
↓ to
M
AP
B
OUNDARIES
. With the
option highlighted, press ENT to check it (turn on) and uncheck it (turn
off). After the option is set, press EXIT to return to the page display.