Lenoxx Electronics pmnHT-4OO - Manual (Page 16)

IB-HT400-WM-E-122502
R L
15
Home Theater System + TV + VCR + Satellite
TV + VCR + SATELLITE RECEIVER CONNECTIONS
1. Follow the above connection diagram and check if you have these items. If your VCR has AUDIO OUT jacks, you may
connect your VCR to your HOME THEATER as shown.
NOTE: Your VCR’s sound will come out of the 2 front speakers plus the subwoofer since the default setting for the
sound output is the same as the audio source from the VCR (2 channel, STEREO). For “Dolby Pro Logic”
(5.1 channel) sound reproduction, press the SURROUND button. The sound will come out of all 5 speakers
plus the subwoofer.
2. Connect your VCR to your TV using a coaxial antenna cable (probably already connected), your VCR’s picture will go
to you TV through the antenna connection.
3. Use an antenna cable to connect the antenna output on the satellite receiver to the antenna input on the VCR the
same as you have it connected now. This HOME THEATER SYSTEM does not change any antenna connections.
4. Insert the AC power cord into an AC outlet.
5. Press the POWER button on the main unit (not the REMOTE) to turn on the main power of the set. Next press the
POWER button on the REMOTE to turn the set on (or off).
6. Press the SOURCE button several times till the TV/VCR indicator lights.
7. Make sure your VCR is on and follow your VCR’s instructions.
8. Go to Page 20 for detailed instructions.
NOTE: No changes
are made to your
antenna cables. The
antenna connections
are the same as you
have them now.
YOUR VCR
BACK OF HT-400
HOME THEATER
SATELLITE RECEIVER CONNECTION BOX
YOUR TV SET
NOTE: On some TVs, this
jack is in the front.
CONNECT ALL SPEAKERS AS SHOWN ON PAGE 8
(OR THE QUICK SETUP DIAGRAM SHEET).