Life Fitness 8235 - Manual (Page 10)

10
0 1 2 3 4 5 6
1/2 1/2 1/2 1/2 1/2 1/2
FIGURE 12
STEP 12:
STEP 11:
FIGURE 11
• Snap two WEIGHT PLATE BUSHINGS (25) into the
top of all twenty WEIGHT PLATES (57) as shown in
FIGURE 11.
25
57
5
3/8 X 1-1/4” 38
20
41
19
57
26
1
56 55
52
• Insert the two GUIDE RODS (5) into the base of
the TOWER (1) as shown in FIGURE 12. Lubricate
the GUIDE RODS (5) with a slicon or teflon spray
that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (26) down
over the GUIDE RODS (5). See FIGURE 12.
• Using EXTREME CARE slide twenty WEIGHT
PLATES (57) down over the GUIDE RODS (5) with
the key-hole facing as shown in FIGURE 12.
• Securely assemble the WEIGHT STACK SHAFT
(19) to the HEAD PLATE (20) using one 3/8 X 1-
1/4” BOLT (38) and one 3/8” WASHER (41).
(Note: The bolt hole in the HEAD PLATE (20)
should be on top.)
• Carefully Slide the HEAD PLATE ASSEMBLY
(19 & 20) down over the GUIDE RODS (5) onto
the weight stack as shown in FIGURE 12.
• Apply one set of WEIGHT STACK LABELS - LBS.
OR 1-25 (55) (56) to each WEIGHT PLATE (57)
as shown in FIGURE 12.
• Slide two 13/16” SHAFT COLLARS (52) over the
GUIDE RODS (5) as shown in FIGURE 12.