System setup – Logic 3 RM-DN2 User Manual
Page 12
6
System Setup
A) SELECT SWITCHES
Before powering on the MV-FLASH M3+:
•
Make sure the corresponding signal cables have been connected from the Composite
or S-Video output jacks.
•
Set the 'PAL/NTSC' switch (S1) to the chosen output format.
B) POWER UP
Config mode
In config mode, you may need either external buttons or 8-segmented touch screen to
operate.
•
Holding button 8 and power on. The OSD menu screen will be shown as follow:
•
Press button 8 to select or press button 7/6 for up/dn.
•
Press button 7or 6 for save and exit.
Auto-Play start up mode*
•
Plug in the external power supply
•
Insert CompactFlash Card containing DV Studio Advanced exported “.pll / .prj” and
other digital files. (e.g. .mpg, .mp3, .jpg) All filename should be in 8+3 format (i.e.
xxxxxxxx.xxx) and avoid using any illegal characters like “~”, “_”, “-“, etc
•
Switch the power 'on/off' switch to 'on'.
•
The first track of the collection of MPEG files will be auto-played.
Sleep mode*
•
Plug in the external power supply
•
Insert CompactFlash Card containing DV Studio Advanced exported “.pll / .prj” and
other digital files. (e.g. .mpg, .mp3, .jpg) All filename should be in 8+3 format (i.e.
xxxxxxxx.xxx) and avoid using any illegal characters like “~”, “_”, “-“, etc
•
Switch the power 'on/off' switch to 'on'.
- 12 -
VOLUME 14 VER 5.00
Y M D H M S
2004 .10 .12 15 : 48 : 44
ID NO: 0712
DATA LOGGING: ON
OSD: ON
SAVE AND EXIT