La Crosse Technology Radio Controlled Temperature Alarm WS-8054U - Manual (Page 3)

B) TEMPERATURE ALARM
1) Remove the battery cover, located on the backside
of the unit.
2) Observe the correct polarity and install 2 AA batteries.
3) Replace the battery cover.
Note: After the batteries have been installed a tone
will sound, and all the LCD's (Liquid Crystal Display) will
briefly light up. The indoor temperature, the date as "1/
1", the weekday as "MON", and the remote temperature
will be displayed (within three minutes). Also, the time
will appear as "-:--" for approximately 1 minute.
TheWWVB search is automatically initiated, and a tower
icon appears and flashes with the time colon (no tower
icon will appear if the WWVB is too weak to be detected,
and the time display will remain on "-:--"). While the
WWVB search is being conducted various numbers will
appear in the time display. After 10minutes, the
temperature alarm will either display the WWVB time,
or discontinue the search if the time is not found. If the
search is cancelled "-:--" will appear in the time LCD.
The temperature alarm will conduct a WWVB search
every hour until the first signal is found. Once the WWVB
time is found, a search is automatically conducted nightly
at midnight. If the signal is found at midnight, the tower
icon will remain, if not, another search will take place
every hour (until 6:00 am) until the signal is found
successfully. If no signal is found during this period, the
tower icon will not appear and the clock will search again
at 12:00 am the next night.
PROGRAM MODE
To enter the program mode hold down the "SET" button
for 2 seconds, until "-5EST" flashes in the date LCD.
The program mode is laid out in a manner that allows
you to program each function separately, or you can
follow the instructions entirely to program the temperature
alarm. Complete programming is usually done for the
initial set-up, and will require you to skip step 1 of
programming sections III through VIII. Press the
"SNOOZE" button at any time to exit the program mode,
or wait approximately 15 seconds for the temperature
alarm to automatically return to normal operation.
I) FUNCTION BUTTONS
There are 3 function buttons located on the front of the
temperature alarm and one on the top. The function
buttons are labeled:"SET", "+", "ALARM", and "SNOOZE"
(the top bar). II) TIME ZONE SETTING
1) Hold down the "SET" button for 2 seconds, the default
setting "-5EST" will flash in the date LCD.
2) Press and release the "+" button to select the
appropriate time zone. There are 13 time zones to
choose from:
R A D I O C O N T R O L L E D
SET
ALARM
OUTDOOR INDOOR DATE
+
TIME
TIME
ALARM
SNOOZE
WWVB Radio reception
Alarm
Icon WWVB
Time
Date
Weekday or
seconds display Indoor temperature
or seconds display
Outdoor
temperature
+ S I Z E A A
+ S I Z E A A
-4ATL Atlantic Time
-5EST Eastern Time (default setting)
-6CST Central Time
-7MST Mountain Time
-8PST Pacific Time
-9ALA Alaskan Time
-10HAW Hawaiian Time
-11, -12 Next tow time zones West of HAW
GMT Greenwich Mean Time
-1, -2, -3GMT Three time zone West of GMT
GB P.11 GB P.10
GB P.13 GB P.12
GB P.15 GB
P.14