LSI 40909G-S - Manual (Page 13)

LSI40909G-S PCI to Fibre Channel Host Adapter for Sun Solaris 2-1
3.75 pc 10.25 pc 11.25 pc 38.25 pc
4.333 pc
12 pc
12.938 pc
13.851 pc
48.583 pc
52.5 pc
34.5 pc
34.732 pc
Chapter 2
Installing the
LSI40909G-S
This chapter provides instructions on how to install the LSI40909G-S and
includes these topics:
•
Section 2.1, “Quick Installation Procedure,” page 2-1
•
Section 2.2, “Detailed Installation Procedure,” page 2-2
2.1 Quick Installation Procedure
This section provides an overview of the installation procedure. If you are
an experienced computer user with prior host adapter installation and FC
setup experience, this section may sufficiently describe the procedure for
you. If you prefer a more detailed guidance for installing the
LSI40909G-S, proceed to
Section 2.2, “Detailed Installation Procedure.”
For safe and proper installation, check the user’s manual supplied with
your computer and perform the following steps.
Step 1. Ground yourself before removing this host adapter board.
Step 2. Remove the LSI40909G-S from the packing and check that it is
not damaged.
Figure 2.1 illustrates an example of this host adapter board.
Also refer to Figure 4.1 on page 4-2 to see a more detailed
drawing of this board.
Step 3. Open your PC cabinet and select an appropriate open PCI slot.
Step 4. Insert the host adapter board.
Step 5. Make any configuration changes.
Step 6. Close your PC cabinet cover.
Step 7. Connect the FC cable to the LSI40909G-S.