Life Fitness M051-00K26-A261 - Manual

M051-00K26-A261
Life Fitness 9100 Series Treadmills
How To...REMOVE AND REPLACE THE WAX PUMP NORPRENE HOSE
Tools Required: Phillips screwdriver, vise grips or clamp, hex key wrench set, socket and ratchet set
Step 1
Turn the power OFF at the switch and unplug
the unit at the electrical outlet.
Step 2
Separate the FRONT and REAR FRAME
ASSEMBLIES (See "How To...").
Step 3
LOCATE the WAX MOTOR on the user LEFT
side of frame chassis.
Step 4
With your fingers, remove the HOSE CLAMP
leading from the WAX CONTAINER and
temporarily seal off the HOSE to prevent
spillage while disconnecting it.
Step 5
Remove the SPRING CLAMP and
DISCONNECT the HOSE leading to the
SPRAY NOZZLE.
Step 6
Use a PHILLIPS HEAD SCREWDRIVER and
remove the 3 screws and remove the cover on
the wax pump.
Step 7
Remove the old NORPRENE HOSE and
discard. Reinstall the new NORPRENE HOSE.
Step 8
Reverse Steps 1 through 6 to return all parts to
their proper positions taking special note to
unkink the WAX CONTAINER HOSE prior to
rejoining the FRONT and REAR FRAME
ASSEMBLIES.
NOTE: THIS IS NORMALLY AN OPPORTUNE TIME TO INSPECT THE WAX SPRAY NOZZLE.
BETWEEN THE BOTTOM OF THE FRAME AND THE STRIDING BELT. PRESS THE
SPRAY NOZZLE IN AND TWIST IT 1/4 TURN TO REMOVE. CLEAN OR REPLACE THE
SPRAY NOZZLE AS DEEMED NECESSARY AND COMPLETE GENERAL CLEANING OF THE UNIT.
CAM
HOSE FITTING
NORPRENE HOSE
HOSE CLAMP
FROM WAX CONTAINER
WAX MOTOR
COVER
3 PHILLIPS HEAD SCREW
TO WAX NOZZLE
SPRING CLAMP