Life Fitness CLUB SERIES UPRIGHT LIFECYCLE M051-00K63-A295 - Manual (Page 18)

T HE O PTIONAL P OLAR
®
T ELEMETRY H EART R ATE C HEST S TRAP
The Lifecycle Bike is equipped with Polar® telemetry, a heart rate monitoring system in which electrodes, pressed against
the skin, transfer heart rate signals to the console. These electrodes are attached to a Polar telemetry heart rate chest
strap that the user wears during the workout. The Polar telemetry heart rate chest strap is optional. Contact Life Fitness
Customer Support Services to order.
See the diagram below for correct positioning of the Polar telemetry heart rate chest strap. The electrodes (A), which are
the two grooved surfaces on the underside of the strap, must remain wet to transmit accurately the electrical impulses of
the heart back to the receiver. Moisten the electrodes. Then, secure the Polar telemetry heart rate chest strap as high
under the chest muscles as possible. The strap should be snug, but comfortable enough to allow for normal breathing.
The transmitter strap delivers an optimal heart rate reading when the electrodes are in direct contact with bare skin. How-
ever, it functions properly through a thin layer of wet clothing.
If it becomes necessary to re-moisten the Polar telemetry heart rate chest strap electrodes, grasp the center of the strap,
pull it away from the chest to expose the two electrodes, and re-moisten them.
Note: If the Lifepulse system sensors are grasped while the chest strap is worn, and if the signals from the sensors are
valid, the on-board computer uses these sensor signals for calculating the heart rate instead of those transmitted by the
Polar telemetry heart rate chest strap.
A A
17