Life Fitness G5 CABLE MOTION G5-001 - Manual (Page 12)

12
STEP 3:
‰ Position two WEIGHT STACK CUSHIONS (13) and GUIDE RODS (8) at the GUIDE ROD BRACKET (B) on the bot-
tom of the FRONT UPRIGHT (1).
NOTE: MAKE SURE THAT THE PLUGGED ENDS OF THE GUIDE RODS (8) ARE FACING UP.
‰ CAREFULLY slide one of the WEIGHT PLATES (9) over the top of the GUIDE RODS (8) and slowly lower the
WEIGHT PLATE (9) on to the WEIGHT STACK CUSHIONS (13).
‰ Continue stacking a total of 15 WEIGHT PLATES (9).
‰ Slide the TOP PLATE (12) over the GUIDE RODS (8) and slowly lower it onto the WEIGHT PLATES (9).
‰ Slide the SELECTOR PIN (11) over the stem of the TOP PLATE (12).
‰ Thread the HEAD PLATE PULLEY (10) into the TOP PLATE (12).
‰ Slide one RETAINING RING (49) over the top of each of the GUIDE RODS (8).
‰ Thread one M10 x 50mm HEX TENSION SCREW (45) into each of the two GUIDE ROD RETAINERS (46). Do not
fully thread the M10 x 50mm HEX TENSION SCREWS (45) into the GUIDE ROD RETAINERS (46).
‰ CAREFULLY slide the GUIDE ROD RETAINERS (46) into the hole under the top of the FRONT UPRIGHT (1). Make
sure the M10 x 50mm HEX TENSION SCREWS (45) in the GUIDE ROD RETAINERS (46) are facing up.
‰ Push the GUIDE ROD RETAINERS (46) up high enough so that the GUIDE RODS (8) can be placed under them.
‰ Lower the GUIDE ROD RETAINERS (46) over the GUIDE RODS (22).
‰ Slide the RETAINING RINGS (49) up. Use External Snap Ring Pliers to secure the RETAINING RINGS (49) into the
groove on the GUIDE ROD RETAINERS (46).
‰ Tighten all frame bolts securely.
13
8
49
46
10
11
12
9
45
1
B
45
46
8
1”