2 electrical characteristics, Electrical characteristics, Lsi20160 mechanical drawing – LSI 20160 User Manual
Page 40: Maximum power requirements, Figure 3.1
3-2
Technical Specifications
Copyright © 2001 by LSI Logic Corporation. All rights reserved.
Figure 3.1
LSI20160 Mechanical Drawing
3.1.2 Electrical Characteristics
The LSI20160 maximum power requirements that include SCSI
TERMPWR under normal operation are shown in
The PCI
PRSNT1
and
PRSNT2
pins are set to indicate a 7.5 W maximum
configuration.
Note:
•
J1: PCI 32-bit universal type board edge connector.
•
J2: 68-pin VHDCI connector for external SCSI connection.
•
J4: 68-pin high density internal SCSI connection.
•
J3: 4-pin low density unshrouded right-angle LED connector.
•
Subsystem Vendor ID is 1000.
•
Subsystem ID is 1060.
J1T-PCI
J4
J3 LED
LSI53C1000
Channel A
Ultra160 SCSI LVD only
J2
Channel A
Ultra160 SCSI LVD/SE
Table 3.1
Maximum Power Requirements
+5 V DC
5%
1.3 A
Over the operating range 0–55
°
C (with SCSI
TERMPWR, supplied to external connection)
+5 V DC
5%
0.40 A
Over the operating range 0–55 ˚C (without
SCSI TERMPWR, supplied to external
connection)
+3.3 V DC
5%
1.00 A
Over the operating range 0–55 ˚C