Lenmar Enterprises PRO9V2 User Manual

Lenmar Enterprises Accessories communication

background image

Instruction Manual for PRO9V2

• Designed for 1 or 2 pieces of NiCd/NiMH 9V batteries
• LED lamp to indicate proper charging

1. Insert 1 – 2 pcs. Of NiCd or NiMH 9V batteries to be recharged into the available

compartment(s) on the charger, observing correct polarity and pressing down
firmly on the battery to make proper connection.

2. Plug the charger with the batteries into an available AC outlet. The LED will

come on for each battery installed to show connection and that charging is taking

3. Observe the charge times shown in the table below. After the proper time has

passed, the batteries are fully charged and ready for use. Unplug the charger and
remove the batteries from the charger.

Charging time:

100 – 120mAh

8 – 10 hours

150 – 180mAh

12 – 14 hours

200 – 230mAh

18 – 20 hours

Charge time may vary depending on actual capacity of battery.

Note: Do not store the batteries in the charger when the charger is not plugged-in. Do not
leave the batteries charging for longer than recommended or damage to the battery may
Caution: Do not attempt to charge any type of battery other than 9V NiCd or NiMH, or
damage to the battery, explosion or personal injury may result.

Another power solution from Lenmar, makers of innovative chargers including the award
winning Mach 1 Speed Chargers, batteries and accessories for camcorders, digital
cameras, laptops, cellular and cordless phones, DVDs, PDAs, and other portable
electronic devices. Check out entire product line at


Your Lenmar battery charger is warranted to be free of defective parts and workmanship
for 2 years from the original date of purchase. Warranties are not transferable. The
warranty excludes damage resulting from accident, misuse, modification, delay or loss of
use, or damage to equipment. To obtain warranty information, visit our website or call
(800) 424-2703