Lanier 5813 - Manual (Page 173)

Designating Areas
157
5
F
Press the [Area Edit] key, and specify your settings, and then press the [OK]
key.
Reference
For details, ⇒ P.165 “Selecting Modes for Designated Areas”.
G
Press the
{{{{Start}}}} key.
Right Angle Polygon and Polygon
A
Place your original on the exposure glass.
B
Press the [Area Editing] key.
C
Press the [R.A. Polygon] or [Polygon] key.
D
Mark the first point with the editor pen.
E
Mark the next points.
Note
❒ When you use Right Angle Polygon mode, mark points that make right an-
gles.
F
After making the last point, press the [Confirm Selection] key.
G
Press the [Area Edit] key, specify your settings, and then press the [OK] key.
Reference
For details,
⇒ P.165 “Selecting Modes for Designated Areas”.
H
Press the
{{{{Start}}}} key.
Cattleya2-2_FM.book Page 157 Thursday, December 14, 2000 8:17 PM