Life Fitness 9700HR - Manual (Page 2)

MO51-00K58-A005
Life Fitness Models 9100 / 9500HR / 9700HR Treadmills
How To… Remove and Replace the Wax Bag (Continued)
Step 10
Slide the HOSE CLAMP over the end of the WAX BAG OUTLET HOSE. Position the
HOSE CLAMP approximately three inches from the end of the WAX BAG HOSE and
engage the HOSE CLAMP onto the WAX BAG HOSE.
Step 11
Cut ½” off the end of the WAX BAG HOSE and slide the WAX BAG HOSE onto the
BARBED NOZZLE on the WAX PUMP INLET HOSE. Be sure to fully seat the WAX
BAG HOSE. Release the HOSE CLAMP.
Step 12
Replace the WAX BAG ACCESS PANEL and secure with the two WAX BAG ACCESS PANEL SCREWS.
FIRST TIME INSTALLATION IS NOW COMPLETE.
IF WAX BAG IS BEING REPLACED, CONTINUE THROUGH STEP 21.
Step 13
Reset the WAX FILL STATISTICS as follows.
Step 14
Press and hold the PAUSE KEY. While holding the PAUSE KEY press the CLEAR KEY twice. Continue to hold the
PAUSE KEY until the DISPLAY reads “ SERVICE MENU.”
Step 15
Press any UP ARROW KEY until you see “MAINTENANCE” in the DISPLAY. Then press ENTER. The DISPLAY
will begin to scroll automatically through available options.
Step 16
When the DISPLAY reads “REFILL WAXER SYSTEM”, press the ENTER KEY. The DISPLAY will read “REPAIR
LOGGED.”
Step 17
Wax replacement is now complete.
Step 18
To verify that the wax refill has been completed correctly, press the CLEAR KEY once to return to the “SERVICE
MENU.”
Step 19
Using any of the UP ARROW KEYS, scroll until “INFORMATION” is displayed. Then press ENTER.
Step 20
Press any of the UP ARROW KEYS until “WAX MOTOR INFO” appears in the DISPLAY. Press ENTER and verify
that the DISPLAY reads “100/100 FULL.”
Step 21
Press the CLEAR KEY three times to exit diagnostic.
WAX BAG REPLACEMENT IS NOW COMPLETE.
Engage
Release