Lennox Hearth M5390 - Manual (Page 17)

15
English
8.1
8.2
8.3
8.1
8.2
8.3
8.1
8.2
8.3
9.1
9.2
9.3
9. Reset/Pairing
9.1 Under start-up, keep pressing
the Answer/End button for three
seconds. Alternatively, remove the
snap-on cover and press the reset
button on the headset for three
seconds.
Visual indicator on headset will
light constant blue.
1)
9.2 Then press reset button on
base unit for 3 seconds. Visual
indicator on base unit will light
constant blue.
9.3 Make sure headset and base
are within 1 m of each other.
When pairing is successful, both
visual indicators will flash blue 5
times, and the visual indicator on
base unit will turn
to steady green.
In order to clear the pairing list
in the base, press and hold the
reset button underneath the base
for 5 seconds. In order to clear
the pairing list in the headset,
press and hold the reset button
on the headset for 5 seconds.
Note that after resetting, a new
pairing sequence has to be
initiated.
1) Note: The headset is already paired with the base unit from the factory. Pairing should only be necessary if
a new headset has to work with an existing base unit (or vice versa).
~ 3 sec.
~ 3 sec.
1 m