LevelOne FNS-1000 - Manual (Page 6)

support FAT and NTFS file format
USB Eject Button Press and release to prepare the USB device for removal. When the USB LED
starts blinking slowly, it is safe to remove the USB device.
LAN
connector
Use this to connect the NAS to your 10BaseT or 100BaseT hub.
Power Switch
This is a spring-loaded "Soft Switch".
If power is Off, press once to turn On.
If power is On, press once to start the Shutdown sequence. During Shutdown, the
Ready LED will blink. When Shutdown is completed, all LEDs will turn off.
Audible Warnings
Audible warnings are given by the following signals.
1 Beep Reset button or power switch is pressed or system is ready to use
2 Beeps
Repeated every 5 seconds
for 1 minute. NAS is a DHCP client, but no DHCP Server responded to the DHCP
client request. This means that the NAS could not obtain a valid IP
address.
3 Beeps
Repeated every 5 seconds
for 3 minute. Hard disk usage exceeds 98%
Page 4