Pride Mobility Jazzy 600 3SP - Manual (Page 24)

24 www.pridemobility.com Jazzy 600 Series
V . C O M F O R T A D J U S T M E N T S
10. Reinstall the retaining clips from step 8.
11. Remove each screw from the trapeze bars and
apply thread lock.
12. Reinstall each screw into the trapeze bars and
tighten.
13. Reinstall the seat.
14. Reconnect the controller connector(s) to the power
base.
15. Reinstall the rear shroud by aligning the side and
back tabs with the holes in the main shroud. Gently
push down and forward until all four tabs lock into
place.
Seat Position Adjustment
You can move the seat forward or rearward by chang-
ing the extrusion mounting position.
To change the seat position:
1. Unplug the controller connector(s) from the power
base.
2. Remove the seat from the power base.
3. Remove both extrusions from the bottom of the
seat.
4. Reposition the extrusions on a different set of
mounting holes. You must move both extrusions
the same number of holes either forward or back-
wards. See figure 16.
5. Fasten the extrusions back onto the bottom of the
seat.
6. Reinstall the seat.
7. Reconnect the controller.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat,
you can adjust the seatback angle with the seatback
release lever. The lever is located on the right side of
the seat base. See figure 5.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backwards to the desired position.
3. Release the lever.
Figure 16. Seat Position Adjustment