Pride Mobility Jazzy 600 3SP - Manual (Page 26)

26 www.pridemobility.com Jazzy 600 Series
CONTROLLER BRACKET
SETSCREW
V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away
from the armrest, or change the position of the con-
troller for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or the power base
frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 18.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Gently push down and pull backward at the har-
ness access point on the rear shroud until it
releases. See figure 12.
3. Remove the rear shroud.
4. Unplug the controller connector(s) from the
power base.
5. Cut the wire tie(s) securing the controller harness
to the armrest.
6. Flip up the armrest and loosen the setscrew. See
figure 18.
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew to secure the controller.
11. Use a wire tie to secure the controller harness to
the armrest.
12. Plug the controller connector(s) into the power
base.
13. Reinstall the rear shroud by aligning the side and
back tabs with the holes in the main shroud. Gently
push down and forward until all four tabs lock into
place.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power
Positioning System, refer to the controller adjust-
ment information contained in separate manuals.
Figure 18. Underside of Armrest
Figure 19. Foot Platform Adjustment
FOOT PLATFORM
BRACKET
FOOT PLATFORM
RETAINING PIN