Precor RECUMBENT RBK 800 - Manual (Page 21)

Assembling the Exercise Bike
19
To install the upright support and prepare the cables for
connection to the console:
1.
Attach the lower ends of the following cables to the inner
side of the jack panel:
 Ethernet cable
 Television cable (for P80 console)
 Power cable (for P80 console)
2. Slide the jack panel back into its bracket in the right side
cover.
3. Using a piece of tape or a plastic tie, bind together the
upper ends of all cables.
4. While your assistant holds the upright support in place
over the body assembly, thread the cables upward
through the support. When you are finished, use a piece
of tape to secure the upper connectors of the cables at
the top of the support.
5. Slide the support into position so that its screw holes line
up with the corresponding holes on the body assembly, as
shown in the following illustration.
Note: If the support is positioned correctly, it rests on a
metal tab in the upright support channel.
Figure 6: Upright support insertion
Important: In the following step, be extremely careful not to
trap or pinch any of the cables between the mounting screws
and their seats.