Precor RECUMBENT RBK 800 - Manual (Page 22)

20
Assembling and Maintaining RBK 800-Series Recumbent Exercise Bikes
6. Insert the two upright support mounting screws through
the openings on the support and into the screw holes on
the body assembly. Tighten the mounting screws
completely using a ³₈-inch hex wrench.
Figure 7: Bolting the upright support into place
Important: In the following two steps, be extremely careful
not to trap or pinch any of the cables between the bike frame
and any of the covers.
7. Reposition the left side cover on the body assembly, then
reattach and tighten the #10 x 1-inch self-tapping screws
holding it in place.
8. Repeat the previous step to reinstall the rear and top
covers.