Panasonic PT-D5600U - Manual (Page 13)

13
VIDEO IN terminal (page 22)
An input terminal for video signals. (BNC)
S-VIDEO IN terminal (page 22)
An input terminal for S-video signals.
(MIN4-pin DIN)
This terminal complies with S1 signals and
automatically toggles between 16:9 and 4:3
according to the size of input signals.
RGB 1 input (RGB 1 IN) terminal (page 22)
A terminal to input RGB or YP
B
P
R
signals. (BNC)
RGB 2 input (RGB 2 IN) terminal (page 22)
A terminal to input RGB or YP
B P R signals. (D-SUB
15-pin female)
DVI-D IN terminal (page 22)
DVI-D signals are applied to this terminal. (24-pin
DVI connector)
LAN terminal (page 38)
This terminal is used to control the projector from
the PC. (10Base-T/100Base-TX compliant)
REMOTE1 lN/OUT terminal (page 16)
When two or more main units are used in the
system, they can be connected and controlled with
M3 stereo mini jack cable available in the market.
REMOTE2 IN terminal
The user can remotely control the main unit by
using an external control circuit to this terminal.
(D-SUB 9-pin female)
SERIAL IN terminal (pages 22, 39)
Use the RS232C serial terminal as an alternative
interface for controlling the projector from your PC.
(D-SUB 9-pin female)
SERIAL OUT terminal (pages 22, 39)
The signal applied to the serial input terminal
appears at this terminal. (D-SUB 9-pin male)
RGB 2 IN
VD SYNC/HD B/P B G/Y R R/P
SERIAL REMOTE 1 REMOTE 2 IN OUT
LAN DVI-D IN RGB 1 IN VIDEO IN S-VIDEO IN
IN OUT
Side-mounted
connection terminals
LAN terminal (10Base-T/100Base-TX)
Connect LAN cable.
LAN 10/100 lamp (Yellow)
Lights up when 100Base-TX
connected.
LAN LINK/ACT lamp (Green)
Lights up when connected.
Flashes when receiving/sending
signals.