Panasonic PT-D5600U - Manual (Page 22)

22
Connection
Example of connecting with PCs
RGB 2 IN
VD SYNC/HD B/P B G/Y R R/P
SERIAL REMOTE 1 REMOTE 2 IN OUT
LAN DVI-D IN RGB 1 IN VIDEO IN S-VIDEO IN
IN OUT
RGB 2 IN
VD SYNC/HD B/P B G/Y R R/P
SERIAL REMOTE 1 REMOTE 2 IN OUT
LAN DVI-D IN RGB 1 IN VIDEO IN S-VIDEO IN
IN OUT
DVI-D Cable (available in the market)
PC with
DVI-D terminal PC
PC
Control PC
Note • For the specifications of the RGB signals that can be applied from the PC, see the data sheet on
page 58.
• If your PC has the resume feature (last memory), the computer may not function properly until the
resume capability is disabled.
• When the SYNC ON GREEN signal is input, do not input sync signals to the SYNC/HD and VD
terminals. Doing so may disrupt the images since, rather than using synchronization initiated by
the GREEN signal, the sync signals of the SYNC/HD and VD terminals will be used instead. Even
if the images are not disrupted, the white balance may be lost. If this is the case, select “USER” as
the “COLOR TEMP.” setting (see page 29), and adjust “W-BAL LOW”.
• The white balance may be lost when the SYNC ON RGB signal is input. If this is the case, select
“USER” as the “COLOR TEMP.” setting (see page 29), and adjust “W-BAL LOW”.
• The EDID settings suited to the equipment connected must be performed when DVI-D signals are
input. (Refer to page 34.)
Example of connecting with AV products
RGB 2 IN
VD SYNC/HD B/P B G/Y R R/P
SERIAL REMOTE 1 REMOTE 2 IN OUT
LAN DVI-D IN RGB 1 IN VIDEO IN S-VIDEO IN
IN OUT
DVD player Video deck
DVD player
Digital Hi-vision video deck
with DVI/HDMI terminal
Digital Hi-vision video deck
Control PC
DVI-D Cable or HDMI-DVI
conversion cable
(available in the market)
D-SUB 9-pin straight cable Red (Connect P
R
)
Blue (Connect P
B
)
Green(Connect Y)
• When connecting with a video deck, be sure to use the one with a built-in time base corrector
(TBC) or use a TBC between the projector and the video deck.
• If nonstandard burst signals are connected, the image may be distorted. If this is the case, connect
a TBC between the projector and the video deck.
• The EDID settings suited to the equipment connected must be performed when DVI-D signals are
input. (Refer to page 34.)
Attention