Panasonic BT-LH1700WP - Manual (Page 8)

8
SDI (HD/SD) terminal (BNC)
IN1 : This is the SDI input terminal (compatible with HD/SD automatic switching).
IN2 : This is the SDI input terminal (compatible with HD/SD automatic switching).
SWITCHED OUT : This is the active through-out terminal for the SDI input signal being displayed on the screen.
* SDI active through-out is only outputted when [SDI1] or [SDI2] is selected using the [INPUT SELECT]
buttons. It is not outputted when anything other than SDI is selected.
VIDEO terminal (BNC)
IN : This is the VIDEO signal (composite signal) input terminal.
OUT : This is the input signal through-out terminal.
Y/C terminal
IN : This is the Y/C signal (S-video signal) input terminal.
OUT : This is the input signal through-out terminal.
YP
B
P
R
/RGB terminal (BNC)
IN : This is the YP
B
P
R
/RGB signal input terminal.
OUT : This is the input signal through-out terminal.
* When using the RGB signal, you can also connect the external synchronizing signal to the SYNC/HD
terminal. When using a PC RGB signal, connect the horizontal synchronizing signal to the SYNC/HD
terminal, and the vertical synchronizing signal to the VD terminal.
VD IN input terminal
This is the vertical synchronizing signal (VD) input terminal used when connecting to a PC RGB signal.
AUDIO input terminal (Pin terminal)
This is the common audio input terminal for all video input terminals.
* When an embedded audio unit BT-YAE1700G (optional) is attached, SDI input audio is automatically
selected by selecting [SDI1] or [SDI2] with [INPUT SELECT].
GPI input terminal (D-SUB 9-pin)
External control is possible by using a GPI signal.
RS232C input terminal (D-SUB 9-pin)
External control is possible by using a RS232C signal.
Rear panel
6 7 8
1 2 3 4 5
Controls and Their Functions
(continued)