Panasonic TC-20LA1H - Manual (Page 11)

11
N
DVD
REC-VCR
STR
TV/AV
1 2 3
4 5 6
7 8 9
F.P. INDEX HOLD
PICTURE
SOUND
SET UP
TV/TEXT
ASPECT
0
SURROUND
Basic controls
Power (Stand-by)
The TV set must first be plugged into the wall
outlet and turned on at the TV ON / Stand-by
button on the top panel.
Press this button to turn the TV set On from
Standby mode, press it again to turn the TV set
OFF to Standby mode. Note:
It is also possible to turn the TV set on from STANDBY
mode by pressing the “Direct Programme Number
Selection” Buttons (0-9) and the “Programme Number
Up or Down” Button, either on the top panel or on the
Remote Control.
Sound Mute
Press to mute the sound completely the “
” symbol will appear.
Press again to restore the previous sound level, and cancel the mute.
Programme Number Selection
Press to select the next higher or lower Programme number.
Volume Adjustment
Press to increase or decrease
the sound volume level.
VOLUME 24
TV/AV Mode Selection
Press to select TV, AV input
signal modes sequentially.
AV1 AV2
Remote control :
Press to display AV1 - AV2 at
the bottom of the screen. Each
coloured button corresponds
to each input signals. For
example, pressing the Red
button selects AV1.
TV/AV
Coloured buttons used for
Teletext functions
(see page 22, 23, 24)
AV Selection
TEXT Index (see page 23)
TEXT hold (see page 23)
VCR / DVD Operation
(see page 24)
Direct Programme Number
• Direct Programme Number Selection
(CH SELECT = POSITION)
You can select the numbers directly by
pressing “Number 0-9” button and the two
digit Numbers by pressing “Two Digit” and
“Programme Number” buttons.
Programme Number 8 ..... 8
Programme Number 12..... , 1 , 2
• Direct Programme Number Selection
(CH SELECT = DIRECT;
except TX-17LA1Q, TX-20LA1Q)
You can select the number directly by
pressing the corresponding programme
number button.
Channel Number 8....... 8
Channel Number 36..... 3 , 6
Channel Number 124... 1 , 2 , 4
Note:
When the Skip setting for Programme
Number 100 through 125 is on, the channel
selection time will be shortened, and thus you
can not input three digits at a time.
03.10.29, 5:46 PM Page 11