Panasonic AJ-HD1400P - Manual (Page 7)

7
Features
(continued)
Cross-convert function
The unit comes with a built-in cross-converter to enable
1080i/59.94 Hz format signals to be converted into
720p/59.94 Hz format signals or, conversely, to enable
720p/59.94 Hz format signals to be converted into
1080i/59.94 Hz format signals.
Cross-convert with 1080i/50 Hz and 720p/50 Hz is also
possible.
HD analog component output
This feature enables HD signals to be monitored with
ease.
Gamma correction of cinema for film
This feature corrects the image from a variable frame
rate camera in cinema gamma mode for film to an image
with film quality.
AC/DC operation
The unit supports AC supply voltages ranging from
100V to 240V and DC12V power supply as well.
Editing function
Using the 9-pin serial remote (RS-422A), assembly or
insertion is allowed.
(Only with 1080i/59.94 Hz, 720P/59.94 Hz, 1080i/50 Hz,
and 720P/50 Hz)
Encoder remote controller function
Using the external encoder remote controller, each
setting for the video output signal can be adjusted.
Follow-on recording function
Using the REC button and PAUSE button together
activates the auto back function, enabling the next
image to follow on from the last image with no
disruptions in the continuity.
On-screen menu settings
Highly detailed and individualized function settings can
be performed on-screen.
Time code
The unit is equipped with a built-in time code generator/
time code reader (TCG/TCR). Since time code signals
can also be input from an external device, regeneration
to an external time code is possible.
Since the backup function using a backup battery is
incorporated in the TCG (time code generator), time
codes during free-run operations are retained even if the
power of the unit is turned off.
Joystick and variable speed playback
The unit is equipped with a joystick (stick controller) for
use of the search function during variable speed
playback.
In addition, the joystick allows convenient setting of the
onscreen menu/time code generator.
PF (Programmable Function) button
The unit is equipped with three PF buttons. Selecting
the three most frequently used setup menus, the menu
settings can be changed with the buttons on the front
panel.
UMID information recording and playback
This unit supports the recording/playback of UMID
(Unique Material Identifier) information in the SMPTE
330M standard. UMID information can be confirmed
with the diagnostic menu.
VANC data recording/playback
VANC data packets that added to the Y stream of HD
SDI can be recorded with the video signal. In addition,
VANC data packets can be played back with the Y
stream of HD SDI. This unit is capable of input and
output through the IEEE1394 standard interface.
AUTO REC Feature
This unit can be connected to our camera recorder
using HD SDI signals. It is possible to remotely turn ON/
OFF the recording feature of this unit by using
overlapped commands.
VTRs that do not support the recording/playback of
UMID information will not playback UMID information
correctly. In addition, when VTRs that do not support
recording/playback of UMID information are connected
to this unit, UMID information will not be recorded
correctly.