Panasonic SC-HT67 - Manual (Page 8)

Simple setup
RQT6191
8
FM ANT AM ANT
AC IN~
LOOP ANT
HOLDER
VIDEO
OUT
S-VIDEO
OUT
TV
AUDIO
IN
LOOP EXT 75 Ω GND
VIDEO
IN
1
2
3
L
R
2
1
Simple setup
Television, antennas and AC power supply cord STEP
2
Connect directly to your television.
Do not connect the unit through a video cas-
sette recorder, because the picture may not
be played correctly due to the copy guard.
Audio cable
(not included)
Video cable
(included)
S video cable (not included)
Television (not included)
Adhesive tape
To household
AC outlet
(AC 120 V, 60 Hz)
FM indoor antenna
(included)
Fix the other end of
the antenna where
reception is best.
AM loop antenna (included)
Keep loose antenna cord away from other
wires and cords.
AC power supply cord
(included)
AM loop antenna
holder (included)
To attach to a wall or other surface
Screw
(included)
Note
The included AC power supply cord is for
use with this unit only. Do not use it with
other equipment.
Conserving power
The unit consumes power (approx. 0.25 W)
even when it is turned off with [Í]. To save
power when the unit is not to be used for a
long time, unplug it from the household AC
outlet. Remember to reset the radio stations
and any other memory items before using
the unit again.
For your reference
Information you enter into the unit’s memory
remains intact for up to a week after the AC
power supply cord is disconnected.
Turn the antenna to
the angle of best
reception and least
interference.
For better images
The S-VIDEO OUT terminal achieves a
more vivid picture than the VIDEO OUT
terminal by separating the chrominance
(C) and luminance (Y) signals before
transmitting them to the television.
(Actual results depend on the television.)
To listen to the televi-
sion through this unit
TV’s S-VIDEO IN
terminal
TV’s AUDIO OUT
terminals