Panasonic VA-20861 - Manual (Page 46)

46
Installation Instructions
INSTALL THE RANGE
ANTI-TIP DEVICE INSTALLATION
An Anti-Tip bracket is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the Safety
Instructions and the instructions that fit your
situation before beginning installation.
WARNING:
• Range must be secured with an approved Anti-Tip
device.
• Unless properly installed, the range could be tipped
by you or a child standing, sitting or leaning on an
open door.
• After installing the Anti-Tip device, verify that it is
in place by carefully attempting to tilt the range
forward.
• This range has been designed to meet all recognized
industry tip standards for all normal conditions.
• The use of this device does not preclude tipping
of the range when not properly installed.
• If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB02K10254.
9
REPLACE THE WIRE COVER
Replace the wire cover on the range back by
sliding its right edge under the retaining tab and
replacing the two screws removed earlier. Make
sure that no wires are pinched between the cover
and the range back.
8 LEVEL THE RANGE
Install the oven racks in the oven and position
the range where it will be installed.
Check for levelness by
placing a spirit level or a
cup, partially filled with
water, on one of the oven
racks. If using a spirit level,
take two readings—with the
level placed diagonally first
in one direction and then the other.
The rear leveling legs must be adjusted prior
to moving the range into position. They can
be adjusted from the bottom at the back
of the range.
Use an open-end or adjustable wrench to
adjust the leveling legs until the range is level.
Replace the drawer or panel.
After the range is level, slide the range away
from the wall so that the Anti-Tip device can be
installed. F
E
D
C
B
A
10
Spirit level
Wire
cover
2 screws to
replace wire
cover
Retaining
tab
Back of range
Adjust from
the bottom back
of range (warming
drawer models)
Back of range
Leg
leveler
Lower
range
Raise
range
Screw must enter
wood or concrete
Attachment to Wall or Floor
Wall Sill Plate
Screw must enter wood
Bracket