Philips DVD616K - Manual (Page 19)

19
DVD616K IFU for /751 3141 016 18911
WIDE(16:9)
4:3
NORMAL/LB
4:3
NORMAL/PS
Setup Menu
Video Out Setup
There are items included in VIDEO OUT PAGE
menu as TV DISPLAY, VIDEO OUTPUT, TV TYPE
BLACK LEVEL, VIDEO MODE, BRIGHTNESS,
CONTRAST, SATURATION, HUE.
1 Press STOP twice.
2 Press SYSTEM MENU to enter its menu.
3 Highlight the SETUP VIDEO OUTPUTitem by
pressing the
34 keys.
4 Press OK.
Video output
In this menu, you can select the video output for
high quality picture.
1 Press the
34 keys to highlight VIDEO OUTPUT
in the VIDEO OUTPUT PAGE menu.
2 Press the OK key to open its submenu.
3 Press the
2 key to highlight the item of the
submenu.
4 Press the
34 keys to choose
an item.
➜ S-VIDEO: Video signals will send an output
from the S-VIDEO on the rear panel of the DVD
player.
➜ YCBCR: If your TV set is equiped with Y/CB/
CR input, you can choose for high quality picture.
5 Press OK.
6 Press the
1 key to return to the SETUP VIDEO
OUTPUT menu.
NOTE: Any selection will not influence the signal
output of composite video.
TV display
Select the aspect ratio of the TV to be
connected.
WIDE ➜ when you connect a wide-screen TV
to the DVD player.
NORMAL/LB ➜ when you connect a normal
TV to the DVD player. Displays a wide picture
with bands displayed on the upper and lower
portions of the TV screen.
NORMAL/PS ➜ when you connect a normal
TV to the DVD player. Displays the wide picture
on the whole TV screen with a por tion
automatically cut off.
Setup the item as follows,
1 Press the
34 keys to highlight the TV DISPLAY
item in the SETUP VIDEO OUTPUT menu.
2 Press the OK key.
3 Enter its submenu by pressing
the
2 key.
4 Move the cursor by pressing the
34 keys to
highlight the selected item.
5 Press OK.
6 Press the 1 key to return to the SETUP VIDEO
OUTPUT menu.
TV type
Before viewing the DVD or VCD, ensure that the
PAL or NTSC setting of the system matches your
TV set.
1 Press the
34 keys to highlight
TV TYPE in the SETUP VIDEO
OUTPUT menu.
2 Press OK.
3 Enter its submenu by pressing the 2 key.
4 Move the cursor by pressing the
34 keys to
highlight the requisite item.
5 Press OK.
6 Press the
1 key to return to the SETUP VIDEO
OUTPUT menu.
NOTE: Choosing NTSC item indicates that the
player will output by NTSC system, Similarly, you
can sacquire PAL system by choosing the PAL item.
And the item MULTI means video output is
depending on the format of DVD or VCD discs.