Philips Comfort-Cire AMC Series - Manual (Page 3)

SELECTION OF LOCATION
Select a convenient location where:
INDOOR UNIT
! The cool air can reach every corner of the
area to be cooled.
! The unit is away from any direct heat
source
! Easy and short routing of the refrigerant
and drain pipes to the exterior.
! There are no flammable gas, alkaline or
acid present in the air.
! Air circulation is not obstructed, preventing
good air circulation.
! The structure where the unit is installed
should be strong enough to support the
weight of the unit and also prevent any
vibration during operation of the unit.
! Figure on the right shows the spacing to the
nearest wall.
OUTDOOR UNIT:
! The condensing unit should be located as
close as possible to the fan coil.
! The air inlet shall be located at least 4” from
the wall or other obstruction for unrestricted
airflow.
! The air outlet shall be located so as to
direct discharged warm air away from the
building. (Avoid low overhanging roofs to
avoid re-circulation of condenser discharge
air on vertical discharge models.)
! Mount the unit on a sturdy base.
! Figure on the right shows the spacing to be
provided.