Philips DVP3345VB - Manual (Page 29)

EN - 29
English
29 DVD to Videotape Duplication
Follow the steps below to copy a DVD to a videotape. This will be possible
only if the DVD is not copy protected.
Before you begin :
● Put a videotape in the cassette compartment. Make sure the tape’s record
tab is intact and the tape is long enough to record the DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so VCR light appears on the front of the DVD/VCR.
● Turn on the TV and set it to the correct Video In channel.
(Check your TV owner’s manual for details.)
1
Press INPUT repeatedly until “DISC” appears on the TV screen.
2
Press SPEED repeatedly until the desired tape speed (SP or
SLP) appears briefly on the screen. Details about tape speed are on
page 58.
3
Press REC I to start recording. “REC” will appear on the display
panel.
4
Press DVD. Press PLAY B to play the disc.
● To pause the recording, press VCR, then press PAUSE F once. “REC”
will flash.
● To resume recording, press REC I or press PAUSE F again. “REC”
will reappear.
● To stop recording, press VCR, then press STOP C.
Helpful Hint
• A Timer Recording or Satellite Link is
not available during DVD to videotape
duplication.
• You cannot copy a DVD to a
videotape if you are using Progressive
Scan.
DVD VCR SETUP
INPUT MENU
REC SPEED MODE
ANGLE SEARCH REPEAT
DISPLAY SUBTITLE ZOOM
TIMER SET
REPEAT
A-B
AUDIO
BACK PAUSE STOP
PLAY
OK
FFW REW
CLEAR TITLE
DISC
TRACKING
OPEN/CLOSE
1 2
6 5 4
7 8 9
0 +10
3
2
3
1
4
DISC
E8E2CCD_E8E2CCH_EN_v1.book Page 29 Friday, March 9, 2012 6:37 PM