Philips BDP7500S2 - Manual (Page 13)

13
5 Play
Play a disc
Caution
Do not place any objects other than discs into the disc •
compartment.
1
Press to open the disc compartment.
2 Insert a disc with its label facing up.
3 Press to close the disc compartment and
start disc play.
To view disc play, turn on the TV to the •
video input.
To stop disc play, press
• .
Note
Check disc/file formats supported (see “Your product” > •
“Playable media”).
If the password entry menu is displayed, enter the
•
password before you can play the locked or restricted
disc (see “Adjust settings” > “Preference Setup” >
[Parental Control] ).
If you pause or stop a disc, the screen saver appears after
•
10 minutes of inactivity. To deactivate the screen saver,
press any button.
After you pause or stop a disc and no button is pressed
•
within 30 minutes, this product automatically switches
to standby.
Play from a USB device
Play or view media files on the following USB devices:
flash drive •
memory card reader •
HDD (This product can detect only a portable •
hard disc drive with USB power peak current
no more than 500mA.)
1
Connect a USB device to the (USB) jack
on the front panel of this product.
2 Press , and select [Browse USB], and press
OK.
A contents menu is displayed.
»
6 Follow the on-screen instructions to complete
the network installation.
After the network installation completes,
»
you can access the services: browse Net TV,
browse PC, BD-Live, software updates.
Tip
You can check the status of the wired or wireless •
connection of this product (see “Adjust settings” >
“Network Setup” >[View Network Settings] or [View
Wireless Settings]).
Use Philips EasyLink
This product supports Philips EasyLink which uses the
HDMI CEC (Consumer Electronics Control) protocol.
You can use one single remote control to control
EasyLink-compliant devices that are connected
through HDMI connectors.
Note
To enable the EasyLink feature, you must turn on the •
HDMI CEC operations on the TV and on other devices
connected to TV. Refer to the TVs/devices manual for
details.
One-touch play
1
Press (standby) to turn on this product.
The TV (if the TV supports one-touch play)
»
automatically turns on and switches to the
correct video-in channel.
If a disc is loaded in this product, disc play
»
automatically starts.
One-touch standby
1 Press and hold (standby) for more than 3
seconds.
All the connected devices (if the device
»
supports one-touch standby) automatically
switch to standby.
Note
Philips does not guarantee interoperability with other •
HDMI CEC devices.
English
EN