Pride Mobility Wrangler - Manual (Page 32)

32 www.pridemobility.com Wrangler
V I . C O M F O R T A D J U S T M E N T S
ARMREST ANGLE ADJUSTMENT
The armrests of your PMV can be adjusted upward or downward by turn-
ing the adjustment dial. See figure 14.
The armrests also pivot upward to make getting on and off of your PMV
easier.
NOTE: If your PMV is not equipped with a reclining high-back seat, as
shown in figure 12, you will be able to adjust the height and width of the
armrest by following the directions below.
ARMREST HEIGHT ADJUSTMENT
ADJUSTMENT
DIAL
Figure 14. Armrest Angle
Adjustment
Figure 15. Armrest Height Adjustment
You will need the following tools to adjust the height of the armrests:
• 5/32” Hex Key •1/8” Hex Key • 7/16” Wrench
1. Loosen the setscrew on the side of the height adjustment tube with the 1/8” hex key.
2. Loosen and remove the acorn nut and screw holding the height adjustment tube in place.
3. Raise or lower the height adjustment tube to the desired height.
4. Align the holes in the adjustment tube with the holes in the armrest upright.
5. Insert the screw through the holes in both the height adjustment tube and the armrest upright.
6. Install and tighten the acorn nut.
7. Tighten the setscrew on the side of the height adjustment tube.
8. Repeat for the other armrest.
ARMREST WIDTH ADJUSTMENT
The armrest width of your PMV can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs at the back of the seat frame. See figures 15 and 16.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs.
Figure 16. Armrest Adjustments
ARMREST ADJUSTMENTS KNOBS
SETSCREW
HEIGHT ADJUSTMENT TUBE
ARMREST
ADJUSTMENT
KNOB
ACORN NUT