Panasonic DVD-LX9 - Manual (Page 12)

12
RQT6915
Getting Started
Preparing the multi cradle and power supply
Household mains
socket
Fit so unit
clicks firmly
into place.
The unit is in the standby condition (the [Í]
indicator lights) when the AC mains lead is
connected. The primary circuit is always
“live” as long as the AC adaptor is
connected to an electrical outlet.
When using only the player
Connect the AC adaptor directly to the player’s
DC IN terminal.
SPEAKER HAUT PARLEUR
COMPONENT VIDEO OUT S VIDEO OUT (480P/480I)
Y P B P R SUB WOOFER CENTRE SORROUND
AUDIO OUT VIDEO OUT 5.1ch 2ch (MIX)
FRONT
R L R L
R 4≠ L
+
-
+
-
SPEAKER HAUT PARLEUR 4≠
Push the levers and insert the wires.
Light gray
No line
Black line
Dark gray
DC IN 9V
Ë
DC IN 9V
1
2
DC IN
DC IN
4
Attach to cradle.
(When the unit is off)
Make sure built-in battery
is attached.
Multi cradle (AC adaptor)
BEFORE USE
Make sure the built-in battery is attached
whenever you use the unit.
DC IN 9V PU
LL
Ë
Remove the
insulation sheet
FOR UNITED KINGDOM ONLY
READ THE CAUTION FOR THE AC
MAINS LEAD ON PAGE 2 BEFORE
CONNECTION.
1
Unwind speaker wire,
then fit the wire back
into the groove of the
speaker base.
2
Twist and pull off the vinyl tip.
3
Connect the speakers.
Caution
Use the speakers only with the
recommended system. Failure to do so
may lead to damage to the connected
equipment and/or the speakers, and may
result in the risk of fire. Consult a
qualified service person if damage has
occurred or if you experience a sudden
change in performance.
≥ To conserve power
When the unit is not going to be used for a long
time, disconnect the AC mains lead from the
mains socket.
The unit consumes a small amount of power
(approx. 0.9 W, when in the multi cradle) when
in standby mode.
∫ To detach
(When the unit is off)
Pull the lever so the unit lifts off the cradle.
RELEASE
VIDEO AUDIO OPT OUT SD CARD : PUSH RELEASE