Panasonic PV DR2714 - Manual (Page 73)

73
Dubbing
Operation
• When appears on the screen while a button is being pressed, it means that the corresponding operation is prohibited by
the unit or the disc.
Manual Dubbing (Tape ĺ DVD)
1
Set remote to VCR mode.
2
Press PLAY. Playback starts. Locate recording start
point.
3
Press PAUSE at desired dubbing start point.
4
Press REC MODE to set recording mode. (Select XP,
SP, LP, or EP mode.)
5
Press DVD REC. Tape playback starts automatically
and dubbing to disc starts. Dubbing information is
displayed on the screen and sub display.
DUBBING
VCRȲDVD
EP XP
VCR side:
• Insert a cassette containing material to be dubbed.
• Select Audio mode. (See page 33.)
Preparation
Sub Display
DVD side:
• When using a cartridge style disc, confirm that it is not rewrite
prohibited.
• Be sure there is enough space on the disc to accommodate the
dubbing.
• Place into Record mode.
• Disengage the disc protect setting.
You can specify the position to start transfer (dubbing) of the
program recorded on the tape to the disc* 1 .
* 1 Only DVD-RAM and non-finalized DVD-R discs can be used for transfer
(dubbing) from a tape.
Note:
• Copy protected VHS tapes cannot be dubbed to a disc.
„ Only the following operations are allowed while
transferring (dubbing)
• Turning unit ON/OFF by pressing POWER.
• Stopping transfer (dubbing) by pressing STOP.
• Selecting input mode by pressing INPUT.
• Changing channels.
- During dubbing, you can select and watch TV stations using
NUMBER keys and Channel Ÿź keys. To switch back to the
dubbing picture, press DVD or VCR. If it is the dubbing picture, CH is
not displayed.
DVD-R RAM
„ To end dubbing
Press STOP.
• When playback (source) side ends and unit enters Stop mode,
or, if dubbing is stopped due to an error, a message will briefly
appear.
Notes:
• While Manual Dubbing (Tape ĺ DVD) is activated, timer recording
cannot be started.
• When the transfer (dubbing) is not started or not executed, the
“DUBBING” indicator blinks for about 7 seconds. Check if the unit is
properly prepared.
• When a Copy-guarded tape is inserted, the message appears on the
display and the recording stops on the spot.