Panasonic KX-PS8100 - Manual (Page 104)

104
Installing Software for Windows
NOTES:
• Before installing the software to Windows 98, make sure that the
provided/not provided SCSI cable and parallel interface cable are
connected properly between KX-PS8100 and your computer.
For connecting the SCSI cable, refer to step 1 to 6 (
page 60 to 62 ).
For connecting the parallel interface cable, refer to step 1 to 3 ( page 64 ).
• The order of installing each device depends on what is detected first.
1 Turn on the printer, then the scanner.
2 When the “Ready” is displayed on the printer’s LCD,
turn on the computer and start Windows 98.
• If “Unknown Device” is displayed, go to “To install the scanner
driver and utilities” (
page 105 ).
• If “Panasonic KX-PS8100” is displayed, go to “To install the
PostScript printer driver” (
page 110 ).