Philips AZ1840 - Manual (Page 7)

General operation
Switching on and off and selecting the
function
1 To switch on the set, press POWER
ON/OFF
on the system.
2 To select your sound source, press
SOURCE
on the front panel of the system
or the respective source buttons on the
remote control: CD,TUNER, MP3 LINK
or USB.
3 To switch off the set, press POWER
ON/OFF
on the system.
Adjusting volume and sound
• To adjust the volume, press VOLUME+/-
on the system (or VOL+/- on the remote
control).
• Press DBB on the system or on the remote
control to turn on or off bass enhancement.
• Press MAX SOUND on the system (or
MAX on the remote control) to optimize the
sound output.
• Connect a headphone to the ; jack on the
rear of the system.
• Press MUTE on the remote control to
temporarily switch off the sound of the system.
Press the same button again to resume.
Digital Tuner
Tuning to radio stations
1 Press SOURCE on the system repeatedly
or press TUNER on the remote control to
select the TUNER (MW or FM) source.
2 Press and hold TUNING +/ - on the
system until the frequency in the display
starts running.
➜ The radio automatically tunes to a station
of sufficient reception.
3 Repeat step 2 if necessary until you find the
desired station.
• To tune to a weak station, press TUNING
+/ -
on the system briefly and repeatedly
until you have found optimal reception.
To improve radio reception:
• For FM, extend, incline and turn the
telescopic aerial. Reduce its length if the
signal is too strong.
• For MW, the set uses a built-in aerial. Direct
this aerial by turning the whole set.
Programming radio stations
You can store up to a total of 25 radio stations
in the memory, manually or automatically
(Autostore).
Manual programming
1 Tune to your desired station (see Tuning to
radio stations
).
2 Press PROG to activate programming.
3 Press PRESET
3/4 on the remote control
once or more to allocate a number from 1
to 25.
4 Press PROG to confirm.
5 Repeat steps 1-4 to store other stations.
Helpful hints: You can erase a preset station by
storing another frequency in its place.
Autostore
Autostore automatically starts programming
radio stations from preset 1. Any previous pre-
sets e.g. manually programmed will be erased.
1 Select MW or FM.
2 Press and hold PROG until displays.
➜ Available stations are programmed (MW or
FM). After all stations are stored, the last
autostore preset station will then automati-
cally play.
To listen to a preset or autostore sta-
tion
Press PRESET
3/4 on the remote control
once or more until the desired preset station is
displayed.
General Operation Tuner
AZ1840_12_CCR_Eng 7/24/08 17:46 Page 7