Planet Technology DVR-860 User Manual
Page 70
Advertising
-64-
Step 3: Screw out the HDD bracket from DVR. (Figure 1~2)
Step 4: Screw HDD onto the HDD bracket, there is two screws for each side. And then screw the HDD bracket back to
the DVR base. (Figure 3~8)
Step 5: Connect the power connector and IDE BUS of DVR to installed HDD. Please make sure to align the HDD
precisely for pin connection. (Figure 9 ~14)
Step 6: Close the upper cover of the DVR and fasten all the screws that you loosened in the step 1.
Advertising